Shell and Tube Heat Exchangers
Steam to Water
Many times, high pressure steam is used to generate building heating water (heating hot water). Howard's Engineering offers a wide variety of steam to water heat exchangers to meet your demands.
Unless otherwise specified, steam to water heat exchangers will be supplied as follows:
1. Steam to water heat exchanger shall be Howard’s Engineering BEU series.
2. Steam to water heat exchanger shall be ASME Code Stamped for 150 PSI at 350°F on the shell and channel side and registered with the National Board of Boiler and pressure vessel inspectors.
3. Steam to water heat exchanger shell to be made of pressure vessel quality carbon steel, minimum schedule 30/40/STD for the shell thickness.
4. Steam to water heat exchanger channel to be made of pressure vessel quality carbon steel.
5. Steam to water heat exchanger tubesheet to be made of pressure vessel quality carbon steel.
6. Steam to water heat exchanger tubes to be made of seamless 90/10 copper nickel.
7. All carbon steel exterior parts to be enameled.
8. Installer will assume responsibility for the correct sizing of all control components
Documents:
The following documents are intended to serve as a guideline for heat exchanger selection, consult Howard's Engineering before making a final selection.